350-401 Implementing Cisco Enterprise Network Core Technologies (ENCOR)

Which set of commands is required to configure and verify the VRF for Site 1 Network A on router R1?

Refer to the exhibit. Which set of commands is required to configure and verify the VRF for Site 1 Network A on router R1?

  • A. R1#ip routing R1#(config)#ip vrf 100 R1#(config-vrf)#rd 100:1 R1#(config-vrf)# address family ipv4 ! R1(config)#interface Gi0/2 R1(config-if)#ip address 10.0.1.1 255.255.255.0 R1#show ip route
  • B. R1#ip routing R1#(config)#ip vrf 100 ! R1(config)#interface Gi0/2 R1(config-if)#ip address 10.0.1.1 255.255.255.0 R1#showip route
  • C. R1#ip routing R1#(config)#ip vrf 100 ! R1(config)#interface Gi0/2 R1(config-if)#ip vrf forwarding 100 R1(config-if)#ip address 10.0.1.1 255.255.255.0 R1#show ip vrf
  • D. R1#ip routing R1#(config)#ip vrf 100 ! R1(config)#interface Gi0/2 R1(config-if)#ip address 10.0.1.1 255.255.255.0 R1#show ip vrf
Answer: Option C.
Explanation: 

No answer description available for this question

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button
error: Alert: Content is protected !!

Adblock Detected

Please consider supporting us by disabling your ad blocker