Cisco 200-105 Exam

Which path does traffic take from R1 to R5?

Scenario –
Refer to the topology. Your company has connected the routers R1, R2, and R3 with serial links. R2 and R3 are connected to the switches SW1 and SW2, respectively. SW1 and SW2 are also connected to the routers R4 and R5.
The EIGRP routing protocol is configured.
You are required to troubleshoot and resolve the EIGRP issues between the various routers. Use the appropriate show commands to troubleshoot the issues.

Instructions –
—– Enter the IOS commands on the device to verify the network operations and to find the answers for the multiple-choice questions.
—– THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION.
—– Click the device to gain access to the console of the device. No console or enable passwords are required.
—– To access the multiple-choice questions, click the numbered boxes on the left of the top panel.
—– There are four multiple-choice questions with this task. Be sure to answer all four questions before clicking the Next button.Which path does traffic take from R1 to R5?

  • A. The traffic goes through R2.
  • B. The traffic goes through R3.
  • C. The traffic is equally load-balanced over R2 and R3
  • D. The traffic is unequally load-balanced over R2 and R3.
Answer: Option A.
Explanation: 

Using the “show ip int brief command” on R5 we can see the IP addresses assigned to this router. Then, using the “show ip route” command on R1 we can see that to reach
10.5.5.5 and 10.5.5.55 the preferred path is via Serial 1/3, which we see from the diagram is the link to R2.

Leave a Reply

Your email address will not be published.

Back to top button

Adblock Detected

Please consider supporting us by disabling your ad blocker
error: Alert: Content is protected !!