Cisco 200-125 Exam

The task is to complete the NAT configuration using all IP addresses assigned by the ISP to provide internet access for the hosts in the weaver LAN. Functionality can be tested by clicking on the host provided for testing.

SIMULATION –
A network associate is configuring a router for the Weaver company to provide internet access. The ISP has provided the company six public IP addresses of
198.18.184.105 – 198.18.184.110. The company has 14 hosts that need to access the internet simultaneously. The hosts in the company LAN have been assigned private space addresses in the range of 192.168.100.17 “” 192.168.100.30.The following have already been configured on the router:
—– The basic router configuration
—– The appropriate interfaces have been configured for NAT inside and NAT outside
—– The appropriate static routes have also been configured (since the company will be a stub network, no routing protocol will be required.)
—– All passwords have been temporarily set to “cisco”
The task is to complete the NAT configuration using all IP addresses assigned by the ISP to provide internet access for the hosts in the weaver LAN. Functionality can be tested by clicking on the host provided for testing.
Configuration information:

Answer: See Explanation.
Explanation: 

Step 1: Router Name –Step 2: NAT Configuration –Step 3: Save Configuration –

Weaver#copy run start –
Verification:
We can verify the answer by pinging the ISP IP Address (192.0.2.114) from Host for testing.
Click “Host for testing”
In command prompt, type “ping 192.0.2.114”. If ping succeeded, then the NAT is working properly.
Screen Shots:

Leave a Reply

Your email address will not be published.

Back to top button

Adblock Detected

Please consider supporting us by disabling your ad blocker
error: Alert: Content is protected !!