- A. show ntp authenticate
- B. ntp associations
- C. ntp server time
- D. ntp authenticate
- E. show ntp associations
Cisco 200-125 Exam
-
Which command can you enter to verify that a router is synced with a configured time source?
-
Which two services can be provided by a wireless controller? (Choose two.)
- A. Layer 3 routing between wired and wireless devices
- B. providing authentication services to users
- C. mitigating threats from the Internet
- D. issuing IP addresses to wired devices
- E. managing interference in a dense network
-
While troubleshooting a GRE tunnel interface issue, show interface command output displays tunnel status up, but line protocol is down. Which reason for this problem is the most likely?
- A. The next hop server is misconfigured.
- B. The route to the tunnel destination address is through the tunnel itself.
- C. The tunnel was just reset.
- D. The interface has been administratively shut down.
-
Which configuration register value can you set on a Cisco device so that it ignores the NVRAM when it boots?
- A. 0x2124
- B. 0x2120
- C. 0x2142
- D. 0x2102
-
Which two types of NAT addresses are used in a Cisco NAT device? (Choose two.)
- A. inside private
- B. inside local
- C. external local
- D. external global
- E. inside global
- F. outside private
-
In a CDP environment, what happens when the CDP interface on an adjacent device is configured without an IP address?
- A. CDP operates normally, but it cannot provide any information for that neighbor.
- B. CDP operates normally, but it cannot provide IP address information for that neighbor.
- C. CDP uses the IP address of another interface for that neighbor.
- D. CDP becomes inoperable on that neighbor.
-
Which API uses HTTP messages to transfer data to applications residing on different hosts?
- A. OpenStack
- B. REST
- C. OpenFlow
- D. OpFlex
-
Which task must you perform to enable an IOS device to use DNS services?
- A. Configure a relay agent information reforwarding policy.
- B. Configure manual bindings.
- C. Configure a name server.
- D. Configure the relay agent information option.
-
Frame flooding can occur in which circumstances?
- A. The destination IP address is missing from the route table.
- B. The destination MAC address is missing from the CAM table.
- C. The source IP address is missing from the route table.
- D. The source MAC address is missing from the CAM table.
-
Which NAT function can map multiple inside addresses to a single outside address?
- A. PAT
- B. SFTP
- C. RARP
- D. ARP
- E. TFTP