Cisco 010-151 Exam

• A. Fabric Interconnect firmware
• B. LAN on Motherboard
• C. Cisco UCS Manager
• D. CIMC
• E. System BIOS

Which four options should be verified? (Choose four.)

• A. Verify the power source to the equipment.
• B. Check for loose HDD cables.
• C. Reseat the DIMMs, CPU, and PCI cards.
• D. Verify that power supplies are receiving power.
• E. Reseat the mezzanine card connector.
• F. Check the CPU sockets for bent pins.
• G. Check the Cisco IMC for fan faults.

• A. Cisco DB-9-to-RJ-45 console cable
• B. laptop
• C. monitor
• D. keyboard
• E. KVM dongle
• F. USB serial adapter

• A. In blade servers, DIMMs can be installed in either 1, 2, 4, or 8 DIMMs per channel.
• B. Rack-mount and blade servers have memory fault LEDs that indicate which DIMM requires attention.
• C. In servers that require pairs of DIMMs, the pairs must be identical (manufacturer, size, part #, and so on).
• D. If the memory in a server is not fully populated, you can install DIMMs in any open slot.

Answer: Option A. C.

No answer description available for this question

• A. blade server status
• B. hard drive status
• C. host OS boot status
• D. CPU status
• E. mezzanine card status
• F. memory DIMM status
• G. fan and power status

• A. Fabric Extender
• B. Power supply
• C. Heat sink
• D. SAS Hard Drive
• E. 2x8GB Kit DIMMs
• F. Mezzanine card

• A. Standby power mode: Power is supplied only to the service processor and the cooling fans, and it is safe to power off the server from this mode.
• B. Power status LED. Green indicates that the server is in main power mode and can be safely powered off.
• C. Graceful shutdown: Press and release the power button. The operating system performs a graceful shutdown, and the server goes to standby mode, which is indicated by an amber power status LED.
• D. Disconnect the power cords from the power supplies in your server to completely power off the server.
• E. Only an emergency shutdown can be performed using the power button on the server front panel.
• F. The Cisco UCS C-Series Rack-Mount Server has only one power mode.

• A. Force the server to shut down.
• B. Disassociate the service profile.
• C. Decommission the server.
• D. Perform a graceful shutdown of the server.

• A. The server shuts down.
• B. The server automatically reboots reboot in 3 minutes.
• C. The endpoints on that server cannot be upgraded.
• D. The server is online, but the administrator cannot assign a service profile to that blade.

• A. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 Status tab
• B. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 General tab
• C. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 FSM tab
• D. Servers Tab > Chassis > Server 3 General tab
• E. Status Tab > Chassis > Chassis 1 > Servers > Server 3
• F. Admin Tab > Chassis > Chassis 1 > Servers > Server 3 General tab