200-301 Cisco Certified Network Associate (CCNA)

An engineer has started to configure replacement switch SW1. To verify part of the configuration, the engineer issued the commands as shown and noticed that the entry for PC2 is missing. Which change must be applied to SW1 so that PC1 and PC2 communicate normally?

Refer to the exhibit.

An engineer has started to configure replacement switch SW1. To verify part of the configuration, the engineer issued the commands as shown and noticed that the entry for PC2 is missing. Which change must be applied to SW1 so that PC1 and PC2 communicate normally?

  • A. SW1(config)#interface fa0/2
    SW1(config-if)#no switchport mode trunk
    SW1(config-if)#no switchport trunk allowed vlan 3
    SW1(config-if)#switchport mode access
  • B. SW1(config)#interface fa0/2
    SW1(config-if)#no switchport access vlan 2
    SW1(config-if)#no switchport trunk allowed vlan 3
    SW1(config-if)#switchport trunk allowed vlan 2
  • C. SW1(config)#interface fa0/2
    SW1(config-if)#no switchport access vlan 2
    SW1(config-if)#switchport trunk native vlan 2
    SW1(config-if)#switchport trunk allowed vlan 3
  • D. SW1(config)#interface fa0/1
    SW1(config-if)#no switchport access vlan 2
    SW1(config-if)#switchport access vlan 3
    SW1(config-if)#switchport trunk allowed vlan 2
Answer: Option A.
Explanation: 

No answer description available for this question.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button
error: Alert: Content is protected !!

Adblock Detected

Please consider supporting us by disabling your ad blocker