Cisco 200-125 Exam

Refer to the exhibit. What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2? (Choose two.)

  • A. Router(config)# interface fastethernet 0/0 Router(config-if)# ip address 192.168.1.1 255.255.255.0 Router(config-if)# no shut down
  • B. Router(config)# interface fastethernet 0/0 Router(config-if)# no shut down Router(config)# interface fastethernet 0/0.1 Router(config-subif)# encapsulation dot1q 10 Router(config-subif)# ip address 192.168.10.1 255.255.255.0 Router(config)# interface fastethernet 0/0.2 Router(config-subif)# encapsulation dot1q 20 Router(config-subif)# ip address 192.168.20.1 255.255.255.0
  • C. Router(config)# router eigrp 100 Router(config-router)# network 192.168.10.0 Router(config-router)# network 192.168.20.0
  • D. Switch1(config)# vlan database Switch1(config-vlan)# vtp domain XYZ Switch1(config-vlan)# vtp server
  • E. Switch1(config)# interface fastethernet 0/1 Switch1(config-if)# switchport mode trunk
  • F. Switch1(config)# interface vlan 1
Answer: Option B. E.
Explanation: 
No answer description available for this question

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button
error: Content is protected !!

Adblock Detected

Please consider supporting us by disabling your ad blocker